If the full-automatic ultrasonic cleaning machine is not operated properly, it will endanger all the normal actual operation and application of the cleaning equipment. In order to ensure the actual effect of the specific application of the cleaning equipment, we can not have the same level of understanding, including the power, ultrasonic frequency, machine temperature and other factors of the full-automatic ultrasonic cleaning machine. The higher the temperature of the applied cleaning equipment, The more beneficial it is to the stain dissolution, but when the temperature reaches a certain range, it will endanger the ultrasonic effect of the cleaning equipment and reduce the actual effect of cleaning.

清潔設備的清理時間越長，實際清理效果越好，除材料外，還有許多因素會造成危害，如清潔液的種類和污漬，應用大功率的清潔劑來清洗不能清洗的部件，而應用小功率的精細部件，頻率越低蒸發越好，頻率越高實際效果越好，對于簡單的表面層應用低頻，對于繁雜的表層和深孔，要用大功率清潔劑來清洗，因為大功率清潔劑使用時，會發出滲漏聲，而且清潔劑很容易清洗。

The longer the cleaning time of the cleaning equipment, the better the actual cleaning effect. In addition to the materials, there are many factors that will cause harm, such as the type of cleaning solution and stains, the use of high-power detergent to clean the parts that cannot be cleaned, while the use of small-power fine parts, the lower the frequency, the better the evaporation, the higher the frequency, the better the actual effect. For simple surface layers, the application of low frequency, For complicated surface and deep holes, use high-power cleaner to clean, because when high-power cleaner is used, it will make leakage sound, and the cleaner is easy to clean.

在全自動超聲波清洗機工作時，盡可能不必上升溫度以避免一切正常運作，務必操縱清潔劑的安全系數，禁止在超聲波清洗機中出現別的異常物件，應常常維護和保養全自動超聲波清洗機，有臟東西落入罐底應該馬上刪掉，變更或排盡清潔液要開展設備維護保養清洗用品在室內溫度下的罐里。

When the full-automatic ultrasonic cleaning machine is working, it is not necessary to raise the temperature as much as possible to avoid all normal operation. Be sure to control the safety factor of the cleaning agent. It is prohibited to have other abnormal objects in the ultrasonic cleaning machine. The full-automatic ultrasonic cleaning machine should be maintained and maintained frequently. If dirt falls into the tank bottom, it should be deleted immediately, When changing or draining the cleaning liquid, equipment maintenance shall be carried out, and the cleaning supplies shall be in the tank at indoor temperature.

當全自動超聲波清洗機一切正常工作時，應聽見超音波和儲罐的勻稱響聲，不拌和清潔液的表層，只有在掃出氣孔造成的灑水，在確保清理物件清理的前提條件下，盡量不加溫和間歇性，工作中由于加溫和長期超聲波會提升儲水箱內的溫度。

When the full-automatic ultrasonic cleaning machine works normally, it shall hear the symmetrical sound of ultrasonic wave and storage tank. The surface layer of cleaning solution is not mixed. Only the water spraying caused by scavenging the air hole. On the premise of ensuring the cleaning of cleaning objects, it shall not be heated and intermittent as far as possible. During operation, the temperature in the water storage tank will be increased due to heating and long-term ultrasonic wave.

以上的精彩內容來自：濟南科爾超聲波設備有限公司全自動超聲波清洗機產品的介紹及分享，更多內容請繼續關注我們：http://www.xgsic.com

The above wonderful content comes from the introduction and sharing of automatic ultrasonic cleaning machine products of Jinan Kerr ultrasonic equipment Co., Ltd. please continue to pay attention to us for more content: http://www.xgsic.com